Seafile on openwrt is not working

[bionade24]

@spon901

I installed seafile 6.2.2 on openwrt. The installation works fine without incidents. I was able to configure it ans tart both seafile and seahub without any errrors. However trying to reach it through web browser on 8000 port gave 500 Internal error afte few tens of seconds. No errors were outputted in any log. I tried to enable debug by writing Debug = True in seahub_settings.py but nothing happened. ccnet.log, controller.log and seahub.log contain very few useless information (no change after DEBUG = True) but seahub.log , seahub_django_request.log, access.log error.log and access.log error.log are empty.

Logging should be always enabled, but be aware of SeaFile’s RAM/Swap probems:

Failed to start seafile server

Hi there, thanks for your time! I newly installed seafile on a router running Entware-ng (Entware has seafile-server in its repo). The router is an ARMv7 based Phicomm K3 (BCM4709 Cortex A9 1.4GHz, 512M RAM). The installation finished smoothly and I setup seafile-server according to its guide (I tried both the default port and customized port for the server). But when I was using the script to start the server, the seafile-server reports as follows: [03/18/18 11:00:38] …/common/session.c(132)…